There are times, when shortly after reinstalling the drivers (maybe within 5 or 10 minutes), the driver shuts down or some sort, making my controller unable to be used again, making me re-do the installation again until it works. After every restart, my DS3 controller does not get recognized, and is not ready to use (all 4 red lights blinking)Ģ. Whenever I do this, I might even need to run it a couple of times to work properly (not to mention it sometimes disables my USB keyboard and wireless mouse in the process - in that case I just unplug them before I run the installation).ġ. ![]() ![]() Recently, for probably more than quite a few months now, everytime I want to use my DS3 controller with SCPToolkit I have to reinstall the drivers. Meaning that even after PC restart, whenever I plug my DS3 in it gets recognized and is ready to use and play games with. When I first discovered this SCPToolkit method to use my DS3 on PC, everything was working as intended for a while (the start was probably just a little bit more than 1 year prior to this post). : upgrading from the ScpToolkit v1.6.238.16010 release to the pre-release ScpToolkit v1.7.277.16103-BETA (uninstall old, install new) fixed all the listed problems only reoccurence left is that the service doesn't start immediately after system restart, but that can be fixed with the solution suggested by making a shortcut for it.
0 Comments
Leave a Reply. |